Building That Extra Special Model Railway Table

You’ve finally decided that you want to build your own model railway and the train table that it will need to sit on. Often the first choice for a layout will be a table top or a sheet of plywood. Although this may seem the easiest way, it definitely has its restrictions.

The biggest of these drawbacks is that everything must be on top, and nothing can be below ground level (or table level). That’s when most modelers realize the need to build their own tables to be able to accommodate any sort of model train scenery and landscape they could dream up.

You need to start by planning the size, weight and design of your layout. If one section has more scenery, it will need more support. An L-girder support system is the choice for model layouts. It can give you all the strength needed as well as being very adaptable.

Although L-girder bench work is very strong, it is still inexpensive. It’s very functional and goes together easily. It consists of a platform of girders, cross braces and joists that all work together. Generally the joists are 18 inches apart but they don’t always have to be evenly spaced.

Be careful in choosing the lumber for the table top as well as for the support system. You will need a flat piece for your roadbed to avoid any problems but take care in choosing the support pieces as well. Cheaper grades of lumber may eventually warp and that could spell disaster for your project.

If your layout is larger that 4 x 8 you should still keep the pieces to that size to make them easier to transport in case you want to move your layout. Use wood screws from underneath to assemble the bench work cross members as well as the support risers.

By doing this you will spare the scenery if you happen to loose a screw. Try not to split the wood by using screws that are too large or by placing them in the wrong spots.

Choose any spots carefully that you want to cut for scenery or access. Opinions vary as to whether you should saw holes in the table top before or after the track is placed.

Personally, I think it’s better to do so before the track is added so that the vibration from sawing doesn’t loosen the track or ballast and ruin the smooth run of your operation. This is just my opinion though.

Tabletop layouts tend to be from 48 to 55 inches high. This is adjustable and if you’ve bolted it together instead of using nails or screws, you can change it with just a wrench. It’s best if you can see the tops of highest hills and grades without needing a step stool.

Take the time needed in planning your special train table. It will be well worth it.